Silicone Rubber (Liquid Silicone) for Candle Mold Reproduction, AL/6

• Highly non-stick and extremely accurate in detail reproduction
• Easy to use
• Low sensitivity to moisture
• Minimal linear shrinkage
• Good mechanical properties

• Candles
• Restoration and architectural elements
• Crafts and applied arts (handmade candles, figurines, general objects)
• Reconstructed stone
• Technical stone panels
• Faux stone complements
• Decorative elements for interiors and exteriors
• Scenic effects (masks, theatrical and film elements, etc.)
• Industrial applications (gaskets, spacers, insulation and protective solutions, etc.)

For the technical and safety data sheet, see the attachments.

Instructions for use:

- Ensure the temperature of the silicone and catalyst is at least 25 °C (if stored at lower temperatures, for example in winter, warm it by placing it near a heat source such as a radiator)

- Thoroughly mix the liquid silicone rubber with 5% of the provided catalyst using a spatula (e.g., 50 g per 1 kg of silicone) - Warning: from the moment the catalyst is added to the silicone, you have only 10 minutes to pour it onto the model to be reproduced

- Pour into the container where the object to be reproduced has been placed (secure the object to the bottom of the container with glue)

- Wait 5-6 hours for the silicone to cure (during this time, the temperature should remain around 25 °C - if the temperature is lower, the curing time will be longer)

To speed up curing, you can either slightly increase the catalyst percentage (up to 6.5/7%) or place the finished piece (silicone mixed with catalyst and mold) in an oven at 50/60 °C